4) Replace the Insulation Panel and the Front Panel in their correct positions.
Note: Make sure that the Control Switch is in the “WASH” position and the Cleaning Valve is open.
5)Turn on the power supply, and start the sanitizing process.
6)Turn off the power supply after 15 minutes.
7)Remove the Front Panel and if necessary, the Insulation Panel.
8)Drain the Water Tank. See the above step 5) in “[a] CLEANING PROCEDURE.”
9)Replace the removed parts and the Insulation Panel in their correct positions.
10)Repeat the above steps 15) through 28) in “[a] CLEANING PROCEDURE” two times to rinse thoroughly.
11)Close the Cleaning Valve.
12)Move the Control Switch to the “ICE” position.
13)Replace the Front Panel in its correct position.
14)Clean the Storage Bin with water.
15)Turn on the power supply, and start the automatic icemaking process.
61
