Manuals / Hoshizaki / Kitchen Appliance / Refrigerator

Hoshizaki MWH KML-351MAH, MRH Electrical Connection, 115-120/60/1, Junction Box, Brown, Nwhite

Models: MWH KML-351MAH KML-250MAH MWH KML-631MAH MWH MRH MWH KML-451MAH

1 40

Download 40 pages 33.48 Kb

Page 17

Image 17

KML-250M_H

KML-351M_H

KML-451M_H

WARNING

ELECTRICAL CONNECTION

THIS UNIT MUST BE GROUNDED Failure to properly ground or wire this unit could result in death, serious injury, or severe damage to the icemaker. The white lead must be connected to the neutral conductor of the power source. See diagram below.

115-120/60/1

JUNCTION BOX

	L
	L	BROWN
115-120V		BROWN
115-120V

NWHITE

KML-631M_H

Fig. 3

Page 17

Image 17

Hoshizaki MWH KML-351MAH, MWH KML-451MAH, MRH Electrical Connection, 115-120/60/1, Junction Box, Brown, Nwhite, 115-120V

Contents

Low-ProfileModular Crescent Cuber Issued“A Superior Degree of Reliability” HoshizakiHoshizaki America, IncHOSHIZAKI AMERICA, INC 618 Highway 74 South Complete and detailed explanation of the problemPeachtree City, GA Attn Hoshizaki Technical Support DepartmentCONTENTS serious injury Important Safety Informationappliance or property care of the applianceAdditional Warning for Remote Models WARNING, continuedA. Electrical and Refrigerant Data I. Specifications1. KML-250M H 2. KML-351M H4. KML-631M H 3. KML-451M HModel Number KML-451MAHUnits mm in B. Dimensions/Connections1. Air-CooledModels MAH 2. Water-CooledModels MWH Side 3. Remote Models MRHRear Model Shown KML-631MRHURC-9FHeat of Rejection Units mm inIcemaker AT 90F 32CA. Location II. Installation and Operating InstructionsB. Checks Before Installation C. How to Remove Panels See Fig Fig. 2b D. SetupFig. 2a Intentionally Left Blank Additional Warnings for Remote Models E. Electrical ConnectionFor All Models 115-120/60/1 ELECTRICAL CONNECTIONJUNCTION BOX BROWNSee Figs. 4 through F. Water Supply and Drain Connections1. Icemaker Fig. 4 Air-Cooledand Remote ModelsWater-CooledModels Connection to an Open Drain System2. Water-CooledCondenser a KML-250/351/451MWH 1 Connection to an Open Drain System2 Connection to a Closed Loop System Connection to a Closed Loop SystemWater-CooledModels b KML-631MWH Connection to an Open Drain SystemWater-CooledModels 1 Connection to an Open Drain SystemWater-CooledModels 2 Connection to a Closed Loop SystemConnection to a Closed Loop System Minimum water flow to the condenser is 4 GPM1.Location G. Installation of Remote Condenser Unit4. Line Set Size and Refrigerant Charge 2.Checks Before Installation3.Setup 1Factory Line Set Modification 5. Line Set InstallationaFactory Line Set Installation bField Fabricated Line Set Installation Male Fitting Remote Condenser UnitDO NOT USE THREAD SEALANT After Tight, Tighten an Additional 1/6 Turn6. Electrical Connection 7.Stacking Remote Condenser Unit H. Final Checklist Additional Notice for Remote Models I. StartupA.Maintenance Schedule III. Maintenance1. Cleaning Procedure B. Cleaning and Sanitizing Instructions9Pour the cleaning solution into the water tank 7Turn off the power supply after 15 minutes 4Move the service switch to the WASH position9Move the service switch to the DRAIN position 11Turn off the power supply2.Drain the water tank IV. Preparing the Icemaker for Periods of Non-Use6Close the drain valves V. Disposal HOSHIZAKI AMERICA, INC

ELECTRICAL CONNECTION

115-120/60/1

JUNCTION BOX

BROWN

115-120V

NWHITE