Troubleshooting Guide
Troubleshooting
6. Verify SCSI bus operation: Use the serial connection between the NT workstation and the Fibre Bridge. See Chapter 3, “Fibre Bridge Default Configuration Settings,” on page
• Perform a Fibre Bridge
• Verify device locations using the Fibre Channel to SCSI Mapping menu. See Chapter 3, “Fibre Channel to SCSI Mapping Configuration,” on page
NOTE | If you experience communication difficulty with the Fibre Bridge, |
| confirm that the terminal emulation software (Hyperterminal, or |
| similar) has been configured properly. See Chapter 3, page 6. |
| 7. Verify Fibre Bridge Configuration: Configuration changes may result |
| |
| in an invalid configuration. If you are in doubt about the |
| configuration, refer to “Making Configuration Changes” on page |
| If this procedure fails, contact an HP service representative. |
| 8. Verify devices: If the previous diagnostic procedure have not resulted |
| in a functional connection between the Fibre Bridge and each device, |
| use the following steps: |
| a. Connect the library to a SCSI HBA on the host and restart the |
| workstation. Verify functionality with the SCSI connection. |
| b. Confirm that the library is visible in the SCSI devices folder of the |
| control panel. |
| c. (If DLT) Confirm that there are no error indicators illuminated on |
| the front panel of the library. |
Chapter 4 |
