HP 3300 manual General network settings, Parameter Description

Chapter 4

General network settings

The following table describes the general network settings shown on the network configuration page.

Parameter	Description
Network Status	Status of the HP All-in-One:
	●	Ready: The HP All-in-One is ready to receive or transmit data.
	●	Offline: The HP All-in-One is not currently connected to the
		network.

Active connection type

URL

Network mode of the HP All-in-One:

●Wired: The HP All-in-One is connected by Ethernet cable to an IEEE 802.3 network.

●Wireless: The HP All-in-One is connected wirelessly to an IEEE 802.11b or g network.

●None: There is no network connection.

Note Only one connection type can be active at a time.

The IP address of the Embedded Web Server.

Note You will need to know this URL when you try to access the Embedded Web Server.

Network setup

Firmware	The internal networking component and device firmware revision
Revision	code.
	Note If you call HP Support, depending on the problem, you
	might be asked to provide the firmware revision code.
Hostname	The TCP/IP name assigned by the installation software to the
	device. By default, this is the letters HP followed by the last 6
	digits of the Media Access Control (MAC) address.
Admin	Status of the administrator's password for the Embedded Web
Password	Server:
	● Set: Password is specified. You must enter the password to
	make changes to the Embedded Web Server parameters.
	● Not Set: No password is set. A password is not required for
	making changes to the Embedded Web Server parameters.
mDNS	Rendezvous is used with local and ad hoc networks that don't use
	central DNS servers. To perform name services, Rendezvous
	uses a DNS alternative called mDNS.
	With mDNS, your computer can find and use any HP All-in-One
	connected to your local area network. It can also work with any
	other Ethernet-enabled device that appears on the network.

78 HP Photosmart 3300 All-in-One series