5.Remove four screws (callout 1), and then remove the gear cover (callout 2). Figure 1-36Remove the registration assembly (3 of 3)

1

32

6.Slightly raise the right end of the assembly (callout 3), and then slide it to the right and lift it up to release it and remove it from the product.

Reinstallation tip Insert the left end of the assembly first to reinstall the assembly.

Fuser assembly and paper feed guide

CAUTION: The fuser might be hot. Allow enough time for the fuser to cool after the product power is turned off.

NOTE: The toner cartridge door assembly should be in the closed position when the fuser is removed to make sure that the fuser-drive gear is correctly aligned for reinstallation.

1.Remove the following components:

●Tray 2 cassette

●Right cover. See Right cover on page 12.

●Left cover. See Left cover on page 11.

●Rear cover, rear door, and feed assembly. See Rear cover, rear door, and feed assembly on page 20.

2.Open the rear jam access door

ENWW

Removal and replacement procedures 29