4.Release one tab (callout 1), and then pull the PCA out of the front cover. Figure 1-69Remove the power-switch PCA (3 of 3)

1

Connecting PCA

The connecting PCA is located on the product right side, below the control panel.

1.Remove the following components:

●Tray 2 cassette

●Right cover. See Right cover on page 12.

2.On the right side of the product, disconnect any connectors (callout 1) on the PCA, remove one screw (callout 2), and then remove the connecting PCA.

Figure 1-70Remove the connecting PCA

1

2

ENWW

Removal and replacement procedures 51