6.On the right side of the product, remove one screw (callout 1). Figure 1-58Remove the engine controller assembly (5 of 9)

1

7.On the left side of the product, disconnect the two cartridge-door interlock switch connectors (callout 1), release the cables (callout 2) from the cable guides (callout 3), and then disconnect one connector (callout 4) and one flat cable (callout 5) on the formatter PCA.

NOTE: Place a mark on one of the cartridge-door interlock switch wires before you disconnect them, so that you can reconnect the connectors to the same switch lugs.

Figure 1-59Remove the engine controller assembly (6 of 9)

1

2

3

5 4

44 Chapter 1 Removal and replacement

ENWW