HP 5000 Router manual Options of Boot ROM operation menu include, Through XModem

34CHAPTER 4: MAINTAINING THE ROUTER

4Clear application program password.

This option clears super user password. This option functions for only one time and password authentication for super users is restored after the router is rebooted.

5Ignore configuration file and start up with initial configuration.

6Enter debugging environment in case of faults.

7Boot menu provides two methods for upgrading the program and the Boot ROM sub-menu operations, which are introduced in the following subsections.

Options of Boot ROM operation menu include:

Boot ROM Download Menu:

1:Download Boot ROM with XModem

2:Download Extended Segment of Boot ROM with XModem

3:Restore Extended Segment of Boot ROM from FLASH

4:Backup Extended Segment of Boot ROM to FLASH

5:Exit to Main Menu

Enter your choice(1-5):

This menu provides options to upgrade, back up or restore Boot ROM program. .

CAUTION: It is recommended to upgrade the software under the guidance of the technical support personnel. In addition, when upgrading the router, note to match the version of the Boot ROM software with that of the main software.

Upgrading Application

Program and Boot ROM

through XModem

Protocol

When upgrading the software through the XModem protocol, you can simply use the console port rather than building up another configuration environment.

Upgrading application program

1Enter the Boot menu (refer to the1.1.1 Boot Menu), press <1> to select the XModem protocol for downloading the application program. The following download speeds are available for the router:

Downloading application program from serial ...

Please choose your download speed:

1:9600 bps

2:19200 bps

3:38400 bps

4:57600 bps

5:115200 bps

6:Exit and reboot Enter your choice(1-6):

2Select an appropriate download speed. For example, enter <5> to select the download speed 115200 bps and the router will prompt:

Download speed is 115200 bps. Change the terminal's speed to 115200

bps, and select XModem protocol. Press ENTER key when ready.

3According to the above information, change the baud rate set at the console terminal for keeping it in consistency with the selected software download baud rate. After that, disconnect the terminal (that is [Dial-in/Disconnect]), reconnect it (that is [Dial-in/Dialing]) and then press <Enter> to begin downloading. The system will prompt: