Introduction 41
Upload the application program file or Boot ROM program or configuration file.
ftp>put
local file (Input the name of appplication/Boot ROM program/Configuration file to be uploaded.)
remote file (Input the name of appplication/Boot ROM program/Configuration file to be saved at the router side after uploading.)
After the uploading is completed, the prompt "ftp>" will be displayed again. Enter <dir> to display the name and size of the file on the router. The size of the configuration file will be the same as that of the original file on the host if the uploading is successful.
CAUTION: After you have uploaded Boot ROM program using the put command, you should immediately use the upgrade bootrom [ full ] command to decompress the bootrom/bootromfull program from the root directory Flash, then write it into Boot ROM. At this point, the upgrade of Boot ROM is completed.
Download the application or Boot ROM program or configuration file.
ftp>get
local file (Input the name of appplication/Boot ROM program/Configuration file to be saved.)
remote file (Input the name of ppplication/Boot ROM program/Configuration file at the router side)
4After implementing uploading/downloading, exit the FTP client program.
ftp>quit
Recovering the Lost If the Boot ROM password of router is lost, please contact the local agent of 3Com Router Password Corporation. The technician will help you enter the router's Boot ROM menu and
reset the password.
Installing a Module The procedure for installing a SIC or MIM is provided in the following list and shown in Figure 28.
1Turn the router so the rear panel faces you.
2Turn off the power switch of the router and unplug the power cord.
3Remove the module and match its remote edge with the edge of the slot on the rear panel of the router.
4Push the module into the router until it closely matches the rear panel of the router.
5Fasten the module into the router with the captive screws.
6Power on the router, and check the LEDs of the corresponding slot on the front panel. After the initialization of the module, if the LEDs for the corresponding slot are on, the module operates normally. If the LEDs for the corresponding slot remain off, the POST failed and you should contact your Service representative.
