Chapter 15

Solution This might mean the control panel overlay is not attached, or it is attached incorrectly. Make sure to align the overlay over the buttons on the top of the HP all-in-one and snap it firmly into place.

The control panel display shows the wrong language

Solution Usually, you set the language and country/region when you first set up the HP all-in-one. However, you can change these settings at any time by using the following procedure:

1Press Setup.

2Press 7, and then press 1.

This selects Preferences, and then selects Set Language & Country/Region. A list of languages appears. You can scroll through the list of languages by pressing the and arrows.

3When your language is highlighted, press OK.

4When prompted, press 1 for Yes or 2 for No.

The countries/regions for the selected language appear. Press or to scroll through the list.

5Use the keypad to enter the two-digit number for the appropriate country/ region.

6When prompted, press 1 for Yes or 2 for No.

The wrong measurements are showing in menus on the control panel display

Solution You may have selected the incorrect country/region when setting up your HP all-in-one. The country/region you select determines the paper sizes shown on the control panel display.

To change the country/region, you must first set the default language again. Usually, you set the language and country/region when you first set up the HP all- in-one. However, you can change these settings at any time by using the following procedure:

1Press Setup.

2Press 7, and then press 1.

This selects Preferences, and then selects Set Language & Country/Region.

122

HP Officejet 6200 series all-in-one