Chapter 7

To set default copy settings from the control panel

1Make any needed changes to the Copy settings.

2In the Copy area, press Menu until Set New Defaults appears.

3Press until Yes appears.

4Press OK to accept the settings as the new default settings.

The settings you specify here are only saved on the HP all-in-one. They do not adjust the settings in the software. You can save your most frequently used settings by using the HP Image Zone software that came with your HP all-in-one. For more information, see the onscreen HP Image Zone Help.

Make multiple copies of the same original

You can set the number of copies that you want to print by using the Number of Copies option.

1Make sure you have paper loaded in the input tray.

2Load your original face down on the right front corner of the glass or face up in the document feeder tray.

If you use the document feeder tray, place the pages so that the top of the document goes in first.

3In the Copy area, press Menu until Number of Copies appears.

4Press or use the keypad to enter the number of copies, up to the maximum. (The maximum number of copies varies by model.)

Tip If you hold down either of the arrow buttons, the number of copies changes by increments of 5 to make it easier to set a large number of copies.

5Press Start Copy Black or Start Copy Color.

In this example, the HP all-in-one makes three copies of the original 10 by 15 cm (4 by 6 inch) photo.

Copy a two-page black-and-white document

You can use the HP all-in-one to copy a single- or multiple-page document in color or black and white. In this example, the HP all-in-one is used to copy a two-page black- and-white original.

To copy a two-page document from the control panel

1 Make sure you have paper loaded in the input tray.

38

HP Officejet 6200 series all-in-one