Chapter 3

2Connect the HP JetDirect to the USB port on the rear of your HP all-in-one.

3Do one of the following:

–If you are performing an initial installation of your HP all-in-one, make sure you insert the HP all-in-one installation CD into the CD-ROM drive on your computer and run the HP all-in-one setup wizard.

The network support software for your computer is installed at this time. When the installation is finished, the HP All-in-One Setup Assistant appears on your computer.

–From the Disk Drive, open the HP All-in-One Setup Assistant from the following location: Applications:Hewlett-Packard:HP Photo & Imaging Software:HP AiO Software

The HP All-in-One Setup Assistant appears on your computer.

4Follow the onscreen prompts and provide the information requested. Note Make sure you click TCP/IP Network on the connection screen.

Use Webscan

Webscan lets you perform a basic scan through the HP JetDirect 175x using just a Web browser. It also lets you perform the scan from your HP all-in-one without the device software installed on your computer. Just enter the IP address of the

HP JetDirect in a Web browser and access the HP JetDirect embedded Web server and Webscan.

The user interface for Webscan is unique to using the HP JetDirect and does not support scan-to destinations like the HP Image Zone scanning software. The e-mail functionality of Webscan is limited, so it is recommended you use the HP Image Zone scanning software if you are not connected using the HP JetDirect.

To use Webscan

1Briefly press and release the test button on the rear of the HP JetDirect 175x. The HP JetDirect network configuration page prints on the HP all-in-one.

2Enter the IP address of the HP JetDirect (obtained from the network configuration page) in a Web browser on your computer.

The HP JetDirect Web server opens in the browser window.

3Select Scan.

4Follow the onscreen instructions.

20

HP Officejet 6200 series all-in-one