ProCurve Secure Router Installation Guide

Option Modules

 

 

Interface Modules

1xT1 Interface Module

The 1xT1 Interface Module (see Figure 5) provides a T1 (full T1 or fractional T1) WAN interface for the ProCurve Secure Router. Refer to Table A-3 on page 44 for the T1 connector pinouts, and refer to Table A-12 on page 47 for the backup connector pinouts. An optional backup module is required for backup applications.

Figure 5. 1xT1 Interface Module

Features and Specifications

Operating Modes

•T1/FT1 Frame Relay/Multilink Frame Relay

•T1/FT1 PPP/Multilink PPP

•T1/FT1 HDLC

T1/FT1 Interface

•Supported Standards: AT&T TR 62411, AT&T TR 54016, ANSI T1.403, Bellcore TR 194

•Line Rate: 1.544 Mbps +75 bps

•Line Code: AMI or B8ZS

•Framing: D4 (SF) or ESF

•FT1 Line Rate: DS0 channelized

•Input Signal: 0 to -36 dB (DS1)

•Line Build-Out: 0, -7.5, -15, -22.5 dB (long) or 0 to 655 feet (short)

•Connector: RJ-48C

•DS0 Assignment: Programmable

Clock Source

•Network

•Internal

Physical

•Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D

Diagnostics

•Test Pattern Generation and Detection: 511, QRSS, all ones, all zeros

•Network loopbacks (local and remote); responds to both inband and FDL loop codes

•Alarm generation and detection

•Network and user sets of performance data (15 minutes and 24 hours)

Compliance

•ACTA/FCC Part 68, IC CS-03

•UL/CUL 60950, IEC 60950

•EMC - see Electromagnetic Compatibility (EMC) Table on page 62

Environmental

•Operating Temperature: 0°C to 50°C (32°F to 122°F)

•Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)

•Relative Humidity: Up to 95 percent noncondensing at 30°C (86°F)

•Non-Operating Relative Humidity: Up to 95 percent noncondensing at 30°C (86°F)

•Altitude: Up to 3.05 km (10,000 ft)

5990-3760

Copyright 2006 Hewlett-Packard Development Company, LP

19