ProCurve Secure Router Installation Guide | Unit Installation |
|
|
1Remove power from the unit.
2If the interface module is already installed in the ProCurve Secure Router chassis, remove all connected cables, release the screws at both edges of the interface module front panel, and slide the module out of the chassis.
3Carefully align the P1 connector on the interface module with the J1 connector on the backup module. Using only fingertip pressure so that neither circuit board bends or flexes, ensure that the connectors are firmly seated. Secure the backup module to the interface module using the screws and standoff posts supplied. (See Figure 19.)
4Slide the interface module with the backup module attached into the ProCurve Secure Router chassis, continuing with the normal interface module installation.
2
Eth 0/2
1
Eth 0/1
3
Figure 19. Installing Backup Module and Interface ModuleInstructions for Installing the Interface Modules and Wide Modules1Remove power from the unit.
2Slide the option module into the option slot until the module is firmly seated against the chassis. (See Figure 19.)
3Secure the screws at both edges of the module.
4Connect the cables to the associated device(s).
5Restore power to the unit.
Copyright 2006 | 39 |