
Option Modules | ProCurve Secure Router Installation Guide |
|
|
2xE1 Interface Module
The 2xE1 Interface Module (see Figure 10) provides two E1 interfaces for the ProCurve Secure Router meeting the requirements of
Figure 10. 2xE1 Interface Module
Features and Specifications
Operating Modes
•E1/FE1 Frame Relay/Multilink Frame Relay
•E1/FE1 PPP/Multilink PPP
•E1/FE1 HDLS
E1 Interface
•Supported Standards:
•Line Rate: 2.048 Mbps +50 PPM
•Line Code: AMI or HDB3
•Framing: FAS with optional
•FE1 Line Rate: Channelized timeslot (in multiples of 56/64 kbps)
•Receiver Sensitivity:
•Connector:
Diagnostics
•Test Pattern Generation and Detection: QRSS, 215 - 1, all ones, all zeros
•Network loopbacks
•Alarm generation and detection
•Network performance data (15 minutes and 24 hours)
Clock Source
•Network, internal, and through
Compliance
•ACIF S016, ETSI TBR 12/TBR 13
•EN 60950, IEC 60950, AS/NZS 60950
•EMC - see Electromagnetic Compatibility (EMC) Table on page 62
Environmental
•Operating Temperature: 0°C to 50°C (32°F to 122°F)
•
•Relative Humidity: Up to 95 percent noncondensing at 30°C (86°F)
•
•Altitude: Up to 3.05 km (10,000 ft)
Physical
•Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D
Note | The 2xE1 module supports a single clock source for both E1 interfaces. Changing the |
| clock source on one E1 interface automatically affects the configuration of the other E1 |
| interface. For example, setting the clock to line on the first E1 configures the clock source |
| of the second E1 as through. |
|
|
24 | Copyright 2006 |