Option Modules

ProCurve Secure Router Installation Guide

 

 

1xE1 Interface Module

The 1xE1 Interface Module (see Figure 8) provides an E1 interface for the ProCurve Secure Router meeting the requirements of ITU-T G.703/G.704. The module provides a single 2.048 Mbps network interface. Refer to Table A-4 on page 44 for the pinouts. Refer to Table A-12 on page 47 for the backup connector pinouts.

An optional backup module is required for backup applications.

Figure 8. 1xE1 Interface Module

Features and Specifications

Operating Modes

•E1/ FE1 Frame Relay/Multilink Frame Relay

•E1/FE1 PPP/Multilink PPP

•E1/FE1 HDLC

E1 Interface

•Supported Standards: ITU-T G.703, ITU-T G.704 (CRC-4), ITU-T G.797, ITU-T G.823

•Line Rate: 2.048 Mbps +50 PPM

•Line Code: AMI or HDB3

•Framing: FAS with optional CRC-4

•FE1 Line Rate: Channelized timeslot (in multiples of 56/64 kbps)

•Receiver Sensitivity: -30 dB

•Connector: RJ-48C

Clock Source

•Network

•Internal

Diagnostics

•Test Pattern Generation and Detection: QRSS, 511, all ones, all zeros

•Network loopbacks

•Alarm generation and detection

•Network performance data (15 minutes and 24 hours)

Compliance

•ACIF S016, ETSI TBR 12/TBR 13

•EN 60950, IEC 60950, AS/NZS 60950

•EMC - see Electromagnetic Compatibility (EMC) Table on page 62

Environmental

•Operating Temperature: 0°C to 50°C (32°F to 122°F)

•Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)

•Relative Humidity: Up to 95 percent noncondensing at 30°C (86°F)

•Non-Operating Relative Humidity: Up to 95 percent noncondensing at 30°C (86°F)

•Altitude: Up to 3.05 km (10,000 ft)

Physical

•Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D

22

Copyright 2006 Hewlett-Packard Development Company, LP

5990-3760