Manuals / Brands / Power Tools / Router / HP / Power Tools / Router

HP 7000 dl Router Installing the Encryption Module, Installing a CompactFlash® Card, T1/E1 Mode Dip-Switch, Compact Flash, Compact Flash

1 80

Download 80 pages, 3.06 Mb

Unit Installation	ProCurve Secure Router Installation Guide

Installing the Encryption Module

The Encryption Module slot supports the 7100/7200 IPSec Module. All software options associated with the card become available once the card is installed. Follow these cautions and steps when installing a module.

Caution	Always remove power from the unit prior to removing or installing a module.
	Improper installation may result in damage to the modules.

Instructions for Installing the Encryption Module

1Remove power from the unit.

2Remove the blank cover plate from the Encryption Module slot.

3Slide the module into the Encryption Module slot until the module is firmly seated against the chassis.

4Secure the screws at both edges of the module.

5Restore power to the unit.

6The configuration options for encryption will now be available in the GUI and the SROS CLI.

Installing a CompactFlash® Card

The Compact Flash slot supports any Type 1 CompactFlash® card (16 MB to 1 GB). Follow these instructions when installing the card.

Note	The CompactFlash® card is hot-swappable and can be inserted or removed while power is
	applied to the unit.

Instructions for Installing a CompactFlash® Card

1Slide the module into the Compact Flash slot until the card is firmly seated against the chassis.

2The CompactFlash® options will now be available in the GUI and the SROS CLI.

T1/E1 Mode Dip-Switch

The ProCurve Secure Router dl 8x T1/E1 Wide Module is shipped with the T1/E1 mode switch (located on the circuit board) set to T1 (in the 1 position). If you require E1 functionality, use your thumbnail to slide the switch to the ON position (as shown in the figure below).

Switch Set to T1 Mode

Switch Set to E1 Mode

40

Copyright 2006 Hewlett-Packard Development Company, LP

5990-3760

Contents

Page Page Page Copyright Trademarks Software Licensing Agreement Disclaimer Warranty Table of Contents Page List of Figures List of Tables 1.INTRODUCTION TO THE PROCURVE SECURE ROUTER ProCurve Secure Router 7102dl ProCurve Secure Router 7203dl Features Specifications Unpack and Inspect the System Contents of Shipments Page Note Caution 2.PHYSICAL DESCRIPTION Reviewing the Front Panel Design Front Panel Switches, Interfaces, and LEDs Table 1. ProCurve Secure Router LEDs (Continued) Console Interface 10/100BaseT Ethernet Interface and Activity LEDs Eth 0/1, Eth 0/2 Module Card Slots Reviewing the Rear Panel Design Rear Panel Interfaces 3.OPTION MODULES Interface Modules 1xT1 Interface Module 1xT1 + DSX-1Interface Module 2xT1 Interface Module 1xE1 Interface Module 1xE1 + G.703 Drop and Insert Interface Module 2xE1 Interface Module 1xSerial Interface Module 1xADSL2+ Annex A Interface Module 1xADSL2+ Annex B Interface Module 2xISDN BRI S/T Interface Module 2xISDN BRI U Interface Module 8xT1/E1 Wide Module Page 8xSerial Wide Module Backup Modules ISDN BRI U Backup Module ISDN S/T Backup Module Analog Modem Backup Module 4.UNIT INSTALLATION Tools Required Mounting Options Rack Mounting ProCurve Secure Router Grounding the Router Grounding Requirements Statement Installing Interface and Backup Modules Instructions for Installing the Backup Module Figure 19. Installing Backup Module and Interface Module Instructions for Installing the Interface Modules and Wide Modules Installing the Encryption Module Installing a CompactFlash® Card T1/E1 Mode Dip-Switch Supplying Power to the Unit Supplying Redundant Power to the Unit Page APPENDIX A. CONNECTOR PIN DEFINITIONS Base Unit Pinouts Interface Module and Wide Module Pinouts Table A-6.G.703 Connector Pinouts Table A-7.1xSerial Interface and 8xSerial Wide Module Connector Pinouts Page Backup Connectors Page APPENDIX B. SAFETY AND REGULATORY INFORMATION ESD Precautions Safety Information (English) Safety Instructions Grounding Servicing Accessories Regulatory Model Identification Number Conserver ces instructions de sécurité Informations concernant la sécurité (French) Page Hinweise zur Sicherheit (German) Page Conservare queste importanti istruzioni sulla sicurezza Informationi sulla sicurezza (Italian) Page Conservar estas Instrucciones de seguridad Importantes Consideraciones sobre la seguridad (Spanish) Page Safety Information (Japan) Safety Information (China) FCC Radio Frequency Interference Statement for United States Electromagnetic Compatibility (EMC) Table Page Industry Canada Compliance Information Canadian Emissions Requirements Notice for European Union Notice for France Notice for Japan Notice for Korea FCC-RequiredInformation Declaration of Conformity (USA) Declaration of Conformity (European) Warranty and Customer Service Installation and Maintenance Support Page APPENDIX C. WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE) INSTRUCTIONS Page Page Page Index Numerics