HP E1433A User's Guide
Register Definitions
Page Map Register: This read/write register defines the internal location of the movable window into the device’s DSP bus. (This 512 kB window begins at 512 kB into the device’s A24 registers.) The eight least significant bits of the Page Map register are the page number. These bits are mapped to the internal DSP bus address lines as follows:
Bit 0: | DSP A(17) |
Bit 1: | DSP A(18) |
Bit 2: | DSP A(19) |
Bit 3: | DSP A(20) |
Bit 4: | DSP A(21) |
Bit 5: | DSP A(22) |
Bit 6: | DSP A(30) and A(24) |
Bit 7: | DSP A(31) |
The eight most significant bits of the Page Map Register are always zero (0).
IRQ Config Register: This register configures the first VME Bus interrupt source. It provides for selection of the VME Bus IRQ level used, and a bit mask. It has the following format:
Bit | 3 | ||||
Contents | Mask | Unused | IRQ | IRQ | |
Enabled | Line | ||||
|
|
|
Mask: This is a bit mask used to enable up to eight interrupt causes. A bit value of zero (0) disables the corresponding interrupt source. RESET VALUE: 0
IRQ Enable: A one (1) in this bit enables the generation of IRQ’s. A zero
(0)resets each of the eight interrupt causes and status bits. RESET VALUE: 0
IRQ Line: This field select which VME Bus IRQ line is driven by this device. A value of zero (0) disconnect the interrupt source. RESET VALUE: 0
