HP Book 900 manual Troubleshooting Suggestions, Symptom, Startup

Models: Book 900

1 98
Download 98 pages 619 b
Page 55
Image 55

If you can’t isolate the cause of a problem using the diagnostic tools, you can use the suggestions in the following table to help find the problem.

Symptom

Table 3-2. Troubleshooting Suggestions

 

Call Center:

 

Repair Center:

 

Repair Center:

 

 

Suggestions

 

Likely Causes

 

Comments

 

 

 

 

 

 

 

 

To help determine likely causes, check to see what replaceable modules are involved in the system function and what roles they play. See the table on page 1-14.

Startup

Does not boot on ac or battery

Does not boot on battery (boots on ac)

Does not boot from floppy drive

Error message such as “Invalid system disk” or “Auto IDE error”

Check the power source. Push system-off button.

Unplug the ac adapter and remove battery, then reconnect power.

Remove any RAM board and try again. Reinsert and try again.

Check battery level on battery LEDs.

Check battery contacts. If available, try another battery.

Check floppy drive contacts.

Try reseating the external module bay cable and the module into the bay.

Try using alternate connection (with accessory floppy cable or external module bay).

Check boot order in BIOS Setup.

Check that floppy boot is enabled in BIOS Setup.

Check for a disk in floppy drive.

Remove and reinsert hard drive.

Check boot order in BIOS Setup.

AC adapter.

RAM board.

CPU module.

Motherboard.

BIOS IC.

LCD module.

Hard drive.

Battery or contacts. Motherboard.

Floppy drive or contacts.

Accessory floppy cable.

External module bay. Motherboard.

Hard drive contacts. Hard drive.

Check ac adapter. Remove any RAM boards and retry.

If power status light does not turn on, reprogram or replace BIOS IC, replace motherboard.

If power status light turns on but display remains off, try external monitor. If monitor shows successful boot, replace LCD module. If monitor shows activity but BIOS does not complete, replace CPU module. If monitor is blank, replace CPU module, replace motherboard.

If power status light and display turn on, BIOS completes, but OS does not start from hard disk or from floppy drive, replace CPU module, then motherboard. If OS starts from floppy drive, reload hard drive, replace hard drive.

If unit boots from floppy drive, check for corrupt files on hard drive, reload hard drive, replace hard drive.

HP OmniBook 900

Troubleshooting and Diagnostics

3-5

Page 55
Image 55
HP Book 900 manual Troubleshooting Suggestions, Symptom, Startup