HP Book 900 manual System Devices Menu Default, Security Menu Default

System Devices Menu		Default
PS/2 Pointing Devices	Sets whether internal pointing devices are automatically	Auto
	disabled when an external PS/2 pointing device is detected, or
	whether both internal and external devices are active. This is
	required for the scroll wheel on a PS/2 mouse to function.
Internal Pointing Devices	Enables one or both built-in PS/2 devices.	Both
External Fn Key	Sets whether left-CTRL + left-ALT on an external keyboard is	Enabled
	interpreted as the Fn key.
IDE Controller	Enables the primary (hard drive) and secondary (optional CD-	Both
	ROM drive) controllers.
FDD Controller	Enables the floppy drive.	Enabled
Serial Port	Sets how the serial port is configured by the BIOS (specified	Enabled
	or automatic).
Base I/O address	Sets the I/O address and interrupt.	3F8h, IRQ4
Infrared Port	Sets how the infrared port is configured by the BIOS (specified	Disabled
	or automatic).
Mode	Sets the hardware to support SIR (Standard IR), ASK IR	SIR
	(amplitude shift keyed IR), or FIR (Fast IR) infrared
	communications. (Driver installation required.)
Base I/O address	Sets the I/O address and interrupt.	2F8h, IRQ3
DMA channel	For Fast IR mode, sets the DMA channel.	DMA3
Parallel Port	Sets how the parallel port is configured by the BIOS (specified	Enabled
	or automatic).
Mode	Sets the port to normal, bidirectional, EPP, or ECP.	ECP
Base I/O address	Sets the I/O address.	378h
Interrupt	Sets the interrupt.	IRQ7
DMA channel	For ECP mode, sets the DMA channel.	DMA3
OmniBook 900†:	Sets how the audio system is configured by the BIOS	Enabled
Audio	(specified or automatic).
SB I/O address	Sets the Sound Blaster I/O address.	220h
WSS I/O address	Sets the Windows Sound System I/O address.	530h
AdLib I/O address	Sets the AdLib synthesizer I/O address.	388h
Interrupt	Sets the interrupt.	IRQ5
1st DMA channel	Sets the DMA channel for playback.	DMA1
2nd DMA channel	Sets the DMA channel for recording.	DMA0

Security Menu		Default
User Password Is	Shows if a user password is set.	Clear
Administrator Password Is	Shows if an administrator password is set.	Clear
Set User Password	Press ENTER to set, change, or clear user password.
	Password length can be no longer than 8 characters, 0-9, A-Z,
	and cannot include special or accented characters.

Set Administrator Password

Smart Card Security

Press ENTER to set, change, or clear administrator password. This password protects BIOS Setup settings. Password length can be no longer than 8 characters, 0-9, A-Z, and cannot include special or accented characters.

Available only if a smart card accessory is installed. Sets	Disabled
whether the password is read from a smart card instead of
entered from the keyboard.

Boot	Sets whether a password is required when the computer	Enabled
	boots.
Resume	If boot security is enabled, sets whether a password is	Enabled
	required when resuming from a suspended state.
Undock	If boot security is enabled, sets whether a password is	Disabled
	required when undocking the OmniBook.

HP OmniBook 900 Troubleshooting and Diagnostics 3-25