Getting Started

1.6.1Label Loading Instructions

1.Disengage the Printhead by rotating the Head-Lift Lever counter-clockwise to the ‘up’ position.

2.Slide the Media Guide to the outer edge and rotate it to the ‘down’ position.

3.Slide the Retainer to the outer edge of the Supply Mount.

4.Place the label roll on the Supply Mount and slide the Retainer firmly against it.

5.Insert the label stock as shown in Figure 1-6.

6.Rotate the Media Guide ‘up’ and slide it to the edge of the media.

7.Engage the Printhead by rotating the Head-Lift Lever clockwise and locking in the ‘down’ position.

8.Set the Media Width Adjustment Cam according to the media width, (see Table 1-1).

Cam SettingMedia Width

1

Up to 1 "

2

Greater than 1", Up to 2"

3

Greater than 2", Up to 3"

4

Greater than 3", Up to 4.1"

Table 1-1 Media Width Cam Settings

10

DMX 400/430 Operator’s Manual