Creating Labels Using Internal Batch Software

Copy Module:

Copies graphic images and/or label

 

formats from one memory module to

 

another. Be certain that the write protect

 

switch is ‘on’ for the source module and

 

‘off’ for the destination module.

Metric:

Each time the number 3 is pressed, the

 

screen will toggle between metric ‘No’

 

and metric ‘Yes’.

Print Test Label:

Prints a Printhead Test Label and is used

 

as a relative gauge of Printhead condition

 

and wear.

System Test Label:

Lists all current Printer settings and

 

checks both ROM and RAM. Prints a

 

Printhead test label after the system test.

Edit Module Name:

This will allow you to change the name of

 

the module.

Reset Printer:

This is the same as the <SOH #>

 

command in the standard printer mode. If

 

switch 7 is on then the internal batch will

 

take over.

Exit To RS-232C System:

This is the same as turning Switch 7 ‘off’

 

and resetting the Printer. You can use the

 

<STX g> command to enter the Internal

 

Batch without using switch 7 in the rear

 

of the Printer.

Pack Module Data:

All the label formats are stored in a 256K

 

flash module; therefore, only the entire

 

module can be cleared. For this reason,

 

the data will occasionally need to be

 

packed from time to time when the

 

memory becomes low.

52

DMX 400/430 Operator’s Manual