Getting Started

1.6.2Adjusting Printhead Pressure

1.Disengage the printhead by rotating the Head-Lift Lever counter-clockwise to the ‘up’ position.

2.Extend the Media Width Adjustment Cam outward from its mounting bracket until the notch on the cam clears the notch on the mounting bracket.

3.With the cam in the extended position, rotate it counter- clockwise or clockwise to the desired width setting. The numbered notch on the top right corner of the cam identifies the media width setting. (Figure 1-7 shows the cam being changed from the four position to the one position).

4.When the cam is set to the desired media width setting, return it to its rest position. Make sure that the bracket détente is fully seated in the cams notch.

5.Engage the Printhead by rotating the Head-Lift Lever clockwise to the down position.

Figure 1-7 Adjusting Printhead Pressure

DMX 400/430 Operator’s Manual

11