Appendix

A

In This Appendix

Set Up Codes

A-2

Tip

Do not point your remote control directly towards the iPAQ Music Center while setting codes.

Programming your Remote Control

1.Press and hold the

Code Set button

Aon the remote control for 3 seconds. The LED will blink twice.

2.Press the A/V PWR button and enter the first 4 digit code for your brand. The LED will blink twice to confirm a valid code has been programmed.

3.Press the A/V PWR button. Your A/V receiver should turn off. If your A/V receiver does not respond, repeat steps 2-3, trying each code listed for your brand until you find the correct one.

4.To program the TV, repeat steps 1-3 but press the TV PWR button on steps 2 and 3.

IPAQ MUSIC CENTER—GETTING STARTED

APPENDIX A-1

Page 63
Image 63
HP Music MC-1 manual Appendix, Programming your Remote Control