HP p550 manual Configuring a Startup Image, SET Menu Set Up Tab Startup Image, Continue, Reset

Configuring a Startup Image

Procedure

[SET] MENU Set Up Tab Startup Image

Display the photo you want to use as your startup image and then select “On”.

•The startup image does not appear when you turn on the camera by pressing [ ] (PLAY).

•You can specify a photo you recorded as the startup image, or you can use the special startup image provided in the camera’s built-in memory.

•If you select an audio photo as the startup image, the audio will not play at startup.

•Formatting built-in memory (page 95) will delete the current startup image setting.

Specifying the File Name Serial Number Generation Rule (File Numbering)

Procedure

[SET] MENU Set Up Tab File Numbering

Use the following procedure to specify the rule that governs generation of the serial number used in file names (page 86).

	Tells the camera to remember the last used file number. A new file will
	be named using the next sequential number, even if files are deleted or
Continue	if a blank memory card is loaded. If a memory card is loaded and that
	card already has files stored on it and the largest sequential number in
	the existing file names is greater than the largest sequential number
	remembered by the camera, numbering of new files will start from the
	largest sequential number in the existing file names plus 1.
	Restarts the serial number from 0001 whenever all files are deleted or
Reset	when the memory card is replaced with a blank one. If a memory card
	is loaded and that card already has files stored on it, numbering of new
	files will start from the largest sequential number in the existing file
	names number plus 1.

88