HP Rlve 810 G2 manual Removing the hard drive, Installing a hard drive

Removing the hard drive

To remove a hard drive:

1.Save your work and shut down the computer.

2.Disconnect AC power and external devices connected to the computer.

3.Turn the computer upside down on a flat surface.

4.Remove the battery and the battery bay cover(see Removing a battery on page 44).

5.Loosen the 1 hard drive screw. Pivot the hard drive to a forty-five degree angle, and then lift it from the hard drive bay. The hard drive is an SSD, which does not resemble conventional hard drives.

Installing a hard drive

NOTE: Your computer may look slightly different from the illustration in this section.

To install the hard drive:

1.Insert the hard drive into the hard drive bay at an angle, and then lay the hard drive flat in the hard drive bay.

2.Tighten the hard drive screw.

3.Replace the service door (see Replacing the service door on page 55).

4.Insert the battery (see Inserting a battery on page 44).

5.Connect AC power and external devices to the computer.

6.Turn on the computer.

56 Chapter 8 Drives ENWW