HP sv6 manual Changing to stereo monitor mode, Power up the emitters, Add ScreenOption

installation and user information

stereo hardware installation

	Connect power supply transformers to their respective emitters at
	this stage. As with all computer equipment, emitters should be
	surge-protected from hazardous power spikes wherever possible.
	It is recommended that all emitters be powered OFF when
CAUTION
	connecting or disconnecting their cables to any other equipment.
	This can reduce the possibility of harmful power surges to other
	equipment when handling this signal source.

5.Power up the emitters

The power switch for emitters is located on the back side of the device. The switch has three positions -- high, off, and low power. It is recommended that you use the high power position to improve signal performance, especially in rooms with high ambient light or that accommodate larger audiences.

changing to stereo monitor mode

Use the following instructions to change graphics cards and compositor settings to a stereo mode.

1.Add ScreenOption

log in to the master system as root

init 2

In addition to the SlsdVideo resolution settings or the videotiming file specified in /etc/X11/X0screens, add one of the following lines under the ScreenOptions section:

SlsdCompositorStereo Active

SlsdCompositorStereo Passive

Save the /etc/X11/X0screens file

2.Start up the new X server: init 3

This will set all graphics cards in the configuration to the new stereo setting and then bring up CDE.

76 Chapter 2