Configuring HP FTAM/9000
Configuration OverviewConfiguration Overview
This chapter contains the following three sections:
•Configuration Worksheets — This section provides the five configuration worksheets you will fill out before beginning the configuration process.
•Configuration Parameters — This section describes each of the configuration parameters and explains which ones are required or optional and which are default parameters.
•HP FTAM/9000 Configuration — This section provides the specific configuration steps and shows the configuration screens.
Each of the three chapter sections is further divided into three subsections related to either the FTAM Initiator, FTAM Responder, or FTAM Remote Responder. So, for example, if you are configuring the FTAM Initiator, the worksheet is under the “FTAM Initiator Worksheet” heading, the parameter information is under the “FTAM Initiator Parameters” heading, and the configuration steps are under the “To configure the FTAM Initiator” heading.
To configure HP FTAM/9000, you need to copy the configuration worksheets, complete them using the parameter information, and transfer the worksheet information to the FTAM configuration screens. You will also need to provide copies of two of the worksheets to the person who is responsible for configuring the FTAM Remote Responder.
The FTAM configuration is done in three parts: the FTAM Initiator and FTAM Responder, which apply to the local node, and the Remote FTAM Responders (remote FTAM Responder addresses configured in the local node).
After you complete the configuration, complete the verification steps in chapter 3.
16 | Chapter 2 |