Stop a running agent
You can stop the agent from the top menu bar or from the command line.
Using HP SIM to stop the AD agent
1.Initiate this task by selecting Configure →Insight Dynamics Agents→Stop AD Agents from the top menu bar.
2.Using the system list, select the
Apply.
3.Verify the system selection and click Next.
4.A description of the action about to take place is displayed. When you are sure that you want to complete the action, click Run now to stop the agent.
Stopping the agent from the command line
To stop a running agent, enter the following command:
/opt/amgr/bin/amgrd
For the full description of the options available for modifying agent behavior, see “Commands for controlling Application Discovery agent and certificates” (page 55).
Reconfigure a running agent from the command line
To change attributes of the agent while it is running, type on the command line:
/opt/amgr/bin/amgrd
For example, the following command illustrates changing the frequency for collecting data about processes and packages.
/opt/amgr/bin/amgrd
where
•
•
and interval is the time span between polls. Interval may be given in seconds (s), minutes (m), or hours (h).
For example, the following command designates a process collection frequency of 10 minutes and a package collection frequency of 30 minutes:
/opt/amgr/bin/amgrd
For the full range of options, see “Commands for controlling Application Discovery agent and certificates” (page 55).
Checking agent state
To check agent state, access Application Discovery (Tools→Integrated Consoles→Application Discovery...) and select Admin/Config and then AD Agents tab. Locate the Agnt Stat and WBEM Stat columns in the “Hosts/Agents” table.
18 Procedures and examples
