User Manual - Configuration Guide (Volume 3)

Chapter 3

Versatile Routing Platform

Congestion Management

Table QC-3-11Configuring the custom queue according to network layer protocol

Operation

Command

 

 

Configure the custom queue according to the

custom-listlist-number protocol protocol-name queue-

network layer protocol

number [ queue-keyword keyword-value ]

Delete the classification policy in the custom queue

no custom-listlist-number protocol protocol-name

queue-number [ queue-keyword keyword-value ]

 

Here, list-numberis the group number of the custom queue. Queue-number is the queue number, the value of which can be 0-16. protocol-namecan be IP and IPX. The values of queue-keywordand keyword-valueare the same as the values in the priority queue.

2)Configure the custom queue according to the interface configuration

Packets can be classified according to different types of router interfaces into which the packet enters, so that the packets can enter different custom-queues.

Perform the following task in the global configuration mode.

Table QC-3-12Configuring the custom queue according to the interface

Operation

Command

 

 

Configure the custom queue according to the

custom-listlist-number interface type number queue-

interface

number

Delete the policy in the custom queue

no custom-list list-numberinterface type number

3)Configure the default queue

Packet not in compliance with any matching policy in the priority queue should be allocated with a default custom-queue.

Perform the following task in global configuration mode.

Table QC-3-13Configuration the default custom queue

Operation

Command

 

 

Configure the default custom queue

custom-listlist-number default queue-number

Restore the default queue number of the custom queue

no custom-list list-numberdefault

Multiple policies can be defined for a custom queue, and these policies can be applied to a certain interface. When a packet reaches this interface (and sent out from this interface), the system will match for this packet along the policy link. If the packet is matched with a specific policy, it enters the corresponding queue, and the matching is completed. If the packet does not match any policy, it enters the default queue. The number of the default custom queue is 16 by default.

4)Specify the queue length of the custom queue (optional)

The queue length of each priority queue can be specified (the queue length refers to the maximum number of packets that can be accommodated in a queue).

Perform the following task in the global configuration mode.

3-12

Page 93
Image 93
Huawei v200r001 No custom-list list-number interface type number, Operation Command Configure the default custom queue