User Manual - Configuration Guide (Volume 3)

Chapter 1

Versatile Routing Platform

VoIP Configuration

The default value of the configuration command timing interdigit (time interval between the DTMF signals) is 120 ms.

The default value of the configuration command timing wink-duration(wink time delay interval) is 500 ms.

The default value of the configuration command timing wink-wait(wink-wait time interval) 500 ms.

The default value of the configuration command type (E&M trunk type) is 5.

1.2.6 Configuring Global Number Match Policy

To better adapt to the diversity of the subscriber dial plan, the number match policy includes match as per the longest number or the shortest number. When using the longest number match, if the input number length is less than the number length configured by the command destination-pattern, please wait until timeout, and then select the shortest number policy. When using the shortest number match, if the input number length is greater than that configured by the command destination-pattern, then the redundant numbers will be neglected.

Please make the following configurations in the global mode:

Table VC-1-7Configuring the global number match policy

Operations

Commands

 

 

Configure the number match policy of the whole office

voip match-policy { longest shortest }

By default, please use the shortest number match policy.

1.2.7 Configuring the Recovery Method of Voice Board

When the voice board becomes abnormal for some reason, two methods can be adopted to recover the board, i.e., the manual recovery and automatic recovery. After enabling the WATCHDOG, it will monitor the board status every five seconds and will automatically recover the board if any abnormality is detected. In this case, manual interference is not necessary. If WATCHDOG is disabled, the board cannot be recovered automatically if any abnormality occurs and manual recovery is needed.

Please make the following configuration in global configuraiton mode.

1-11

Page 207
Image 207
Huawei v200r001 user manual Configuring Global Number Match Policy, Configuring the Recovery Method of Voice Board