Huawei v200r001 user manual Table DC-1-13Set the idle time of busy interface

User Manual - Configuration Guide (Volume 3)		Chapter 1
Versatile Routing Platform		DDR Configuration
Table DC-1-13Set the idle time of busy interface
	Operation	Command
	Set the idle time of busy interface	dialer fast-idle seconds

3)Set link disconnection time

When a link is disconnected due to failure or onhook, a new connection can be established only after the set time.

Please use the following command in the configuration mode of the dial interface.

Table DC-1-14Set link disconnection time

Operation	Command
Set link disconnection time	dialer enable-timeout seconds

4)Set the maximum waiting time interval from call originating to call connection establishment.

Please use the following command in the configuration mode of the dial interface.

Table DC-1-15Set wait-for-carrier time for port data

Operation	Command
Set the maximum waiting time interval from call originating to	dialer wait-for-carrier-time seconds
call connection establishment.

5)Set access control of the dial interface

Message filtering function can be set for the dial interface. Messages passing the dial interface can be classified into two categories through access control:

zInteresting—messages undergoing access control. When the dial interface receives an interesting message, if the corresponding link has been established, then DDR will send the message through this link and clear idle-time timer. If the corresponding link has not been established, then a call will be sent.

zUninteresting—messages not under access control. When the dial interface receives an uninteresting message, if the corresponding link has been established, DDR will send the message through this link and do not clear idle-time timer. If the corresponding link has not been established, no call will be sent and this message will be discarded.

If no dialer-group has been configured in the interface configuration, or no dialer-list corresponding to dialer-group has been configured in the global configuration, the dial interface cannot send the message.

1-9