Select Restart now in order to have Windows NT automatically restart your computer.

Note: You might need to reinstall Service Pack 5 due to changes to your services or protocols during installation.

12.Check for the following conditions to determine whether the adapter is working correctly and whether installation has been completed successfully:

v The device driver files loaded successfully.

vThere are no error messages logged for the IBMTRP service in the Event Viewer.

vThe adapter LEDs indicate normal operation: Green ON, Amber OFF.

If you experience problems, see “Chapter 4. Problem solving” on page 37.

Windows NT Version 4.0

The following procedure assumes that Windows NT 4.0 has already been installed with networking support. It is highly recommended that you install Service Pack 3 or later from Microsoft before installing the driver.

1.Log on to Windows NT as an administrator.

2.Select Start Settings Control Panel.

3.From the Control Panel window, double-click the Network icon.

4.Select the Adapters tab.

5.Select Add.

6.You will see a dialog box that includes a list of adapters. Select Have Disk....

7.Insert the CD-ROM or the diskette containing the device drivers into the appropriate drive. When prompted, enter the path to the root directory of the CD-ROM or diskette and select OK.

8.In the Select OEM Option dialog box, select IBM Token-Ring PCI Family Adapter and then select OK.

Several work-in-progress panels are displayed, indicating that the driver and its supporting files are being copied to your computer’s hard disk.

9.The Network Control panel is displayed again. There should be an entry in the Installed Adapters list for each token-ring adapter found in the computer.

To change default values for an adapter, select that adapter on the Network Adapters list, and then select Properties. Make the necessary changes and select OK.

Note: Make sure that all of the appropriate protocols are installed to connect to the network. Consult your network administrator if you are unsure of what protocols need to be installed.

10.Select Close to complete the installation.

Note: If TCP/IP is installed as a protocol on the computer, you will now see the TCP/IP configuration panel. Enter all necessary information and select OK.

11.The following message will be displayed:

Your network settings have changed.

You will need to exit and restart Windows NT so that the new settings can take effect.

Select Yes in order to have Windows NT automatically restart your computer.

24IBM 16/4 Token-Ring PCI Management Adapter

Page 32
Image 32
IBM 16/4 Token-Ring manual Select Start → Settings → Control Panel