IBM AA-RWF3A-TE manual SAN Switch shipping carton checklist, Number

Table 3 identifies the carton contents included with your SAN Switch.

Table 3 SAN Switch shipping carton checklist

Number Description

1One SAN Switch Accessories Box containing:

•One 3.0 m (10 ft) RS-232 serial cable; convertible to an RJ-45 connector by removing the adapter on the end of the cable

•Plenum (not shown) — An air duct that attaches to the switch rails, enabling the switch to draw cooler air into the switch from outside the rack, rather than drawing in heated air from within the rack. SAN Switches that require a plenum include:

—SAN Switch 2/16V

—SAN Switch 2/16

—4/8 SAN Switch

—4/16 SAN Switch

—4/32B SAN Switch

•SAN Switch Rack Mount Kit hardware contained in plastic pouches:

• 14 #8-32 x 3/16-inch Phillips pan-head screws with thread lock for the SAN Switch 2/32 (requires twelve screws, six per rail)

• 14 #8-32 x 5/16-inch pan-head SEMS screws for use with the 4/8, 4/16, 4/32, 4/32B and 4/64 SAN Switches (All require ten screws except for the 4/32B SAN Switch which requires six screws)

• Ten #10-32 x 1/2-inch Phillips pan-head screws with captive star lock-washers

• Eight #10 alignment washers

• Eight #10 adapter washers

• Two 1/4-20 hex nuts with captive star lock-washers

• Two 1/4-inch flat washers

• Four rubber feet for mounting on a flat surface (a lab bench, for example)

•EZSwitchSetup CD

•One set of HP StorageWorks product documentation including Safety Guides, User License, Read Me First, and Warranty

•For the 4/8 and 4/16 SAN Switches, one country-specific AC power cord and one PDU power cord (not shown); for the 4/32, 4/32B and 4/64 SAN Switches, two country-specific AC power cords and two PDU power cords (not shown)

2	SAN Switch Rack Mount Kit rail assemblies:
	• Two rear mounting brackets
	•	A right inner rail and a right outer rail
	•	A left inner rail and a left outer rail

3One of the following:

• One HP StorageWorks 4/8 SAN Switch

36 Installing and configuring SAN Switches