IBM AA-RWF3A-TE manual 4/64 SAN Switch port side LEDs, 4/32 SAN Switch nonport side LED patterns

Table 14 describes the 4/32 SAN Switch nonport side LEDs.

Table 14 4/32 SAN Switch nonport side LED patterns

LED name	LED color	Hardware status	Recommended action
Power Supply	No light	Power supply is not receiving	Verify that the power supply is on
Status		power or power is off.	and seated and the power cord is
			connected to a functioning power
			source.
	Steady green	Power supply is operating	No action required.
		normally.
	Steady amber	Power supply fault for one of	Try the following:
	(for more than	the following reasons:	Check the power cable connection.
	5 seconds)	Power cable is disconnected.
			Verify that the power supply is
		Power supply is off.	powered on.
		Power supply has failed.	Replace the power supply.
Fan Status	No light	Fan assembly is not receiving	Verify that the fan assembly is seated
		power.	in the switch.
	Steady green	Fan assembly is operating	No action required.
		normally.
	Steady amber	One or more of the fans in the	Verify that the fan FRU is enabled.
	(for more than	fan assembly failed or the fan	If the fan FRU is enabled, the FRU is
	5 seconds)	FRU was disabled by the user.	faulty and should be replaced.

4/64 SAN Switch port side LEDs

The 4/64 SAN Switch integrates the following port side LEDs:

•System Status LED

•Power Status LED

•Two Ethernet Port LEDs

•One Port Status LED

•Port Speed LED for each port on the switch. These LEDs are displayed below each pair of Fibre Channel ports. The LEDs are located in the array in the same relative positions as the ports.

Figure 26 on page 80 identifies the LEDs on the port side of the switch. Table 15 on page 81 describes the port side LED patterns.

SAN Switch installation guide 79