0031-217 0031-251
0031-217 POE (
number
), pmd (
number
), and dbe (
number
) versions are incompatible.
Explanation: The versions of POE, pmd, and the debug engine (dbe) are incompatible.
User Response: You should check that POE, pmd, and dbe are at compatible PE version
levels. If necessary, install compatible versions.
|0031-218 Partition manager daemon not started by LoadLeveler on node
string
.
|Explanation: The daemon on the indicated node was not started by LoadLeveler, and an
|entry in the /etc/poe.limits file on that node specified that LoadLeveler must be used to start
|the daemon.
|User Response: Set up the Execution Environment (see IBM Parallel Environment for AIX
|Operation and Use, Volume 1) so that LoadLeveler will be used, or contact the System
|Administrator to determine if use of the MP_USE_LL keyword in the /etc/poe.limits file was
|intended.
0031-235 invalid userid received
Explanation: The userid is not valid on this node.
User Response: Run under a valid userid.
0031-237 invalid group id received
Explanation: The group id received by the pm daemon is either negative or non numeric
and therefore not valid.
User Response: Probable system error. Gather information about the problem and follow
local site procedures for reporting hardware and software problems.
0031-243 invalid environment length received
Explanation: The length received by the pm daemon is either negative or non numeric and
therefore not valid.
User Response: Probable system error. Gather information about the problem and follow
local site procedures for reporting hardware and software problems.
0031-247 pmd: setgid <
number
>
Explanation: The pmd was unable to set the groupid for the remote task.
User Response: Probable system error. Gather information about the problem and follow
local site procedures for reporting hardware and software problems.
0031-250 task
number
:
string
Explanation: The given task has received the given signal.
User Response: No response needed.
0031-251 task
number
exited: rc=
number
Explanation: The indicated task has exited. This informational message is displayed when
processing completes normally and when the job is terminated by the <Ctrl-C> interrupt key.
User Response: No response needed.
68 IBM PE for AIX V2R4.0: Messages