IBM P96 Specifications, Self-diagnosisFunction, If the uindicator is green, If the uindicator is flashing orange

Additional Information

Self-diagnosis Function

This monitor is equipped with a self-diagnosis function. If there is a problem with your monitor or computer, the screen will go blank and the uindicator will either light up green or flash orange.

u indicator

If the uindicator is green

1Disconnect the video input cable or turn off the connected computer.

2Press the u button twice to turn the monitor off and then on.

3Press and hold the /button for 2 seconds before the monitor enters power saving mode.

If all four color bars appear (white, red, green, blue), the monitor is working properly. Reconnect the video input cable and check the condition of your computer.

If the color bars do not appear, there is a potential monitor failure. Inform the IBM HelpCenter of the monitor’s condition.

If the uindicator is flashing orange

Press the u button twice to turn the monitor off and then on.

If the uindicator lights up green, the monitor is working properly.

If the uindicator is still flashing, there is a potential monitor failure. Inform the IBM HelpCenter of the monitor’s condition. Be sure to note the model name and serial number of your monitor. Also note the make and model of your computer and video board.

Specifications

Picture tube	0.24 mm aperture grille pitch
	19 inches measured diagonally
	90-degree deflection
Viewable image size	Approx. 365 ⋅ 274 mm (w/h)
	(14 3/8 ⋅ 10 7/8 inches)
	18.0” viewable diagonal
Resolution	Horizontal: Max. 1600 dots
	Vertical: Max. 1200 lines
Standard image area	Approx. 352 ⋅ 264 mm (w/h)
	(13 7/8 ⋅ 10 1/2 inches)
Deflection frequency*	Horizontal: 30 to 107kHz
	Vertical: 48 to 120 Hz
	256 < Total Line < 2048

AC input voltage/current

100 to 240 V, 50 – 60 Hz, Max. 2.0 A

Power consumption	Max. 140 W
Operating temperature	10°C to 40°C
Dimensions	Approx. 462 ⋅ 462 ⋅ 474 mm
	(w/h/d)
	(18 1/4 ⋅ 18 1/4 ⋅ 18 3/4 inches)
Mass	Approx. 27 kg (59 lb 8 oz)

*Recommended horizontal and vertical timing condition

•Horizontal sync width should be more than 1.0 µsec.

•Horizontal blanking width should be more than 3.0 µsec.

•Vertical blanking width should be more than 450 µsec.

Design and specifications are subject to change without notice.

20