IBM Tivoli and Cisco Defining user roles, Click User Management → User Roles → New Roles, 327

6.Under Profile, use the drop-down list to configure the ports as appropriate. Our client was installed on port fa1/0/12, (Figure 7-95)so the profile was set to Control_20.

Figure 7-95 Applying profiles to ports. Note port fa1/0/12

Note: An audit of what is attached to each switchport should be conducted before setting the profile. It is likely that clientless devices (such as printers, faxes, IP phones, and so on) will have a different profile from an end-user workstation, and different user groups may need different profiles applied.

Defining user roles

User roles must be defined to classify the user for the duration of their session. This classification of the user controls traffic policies, bandwidth restrictions, session duration, and VLAN assignment.

1.Click User Management → User Roles → New Roles.

Chapter 7. Network enforcement subsystem implementation 327