Note: The switch’s serial port default settings are listed as follows:
Baud rate | 57600 |
Stop bits | 1 |
Data bits | 8 |
Parity | N |
Flow control | none |
4.When you complete the connection, then press <Enter> key. The login prompt will be shown on the screen. The default username and password are shown as below:
Username = admin | Password = admin |
•Set IP Address, Subnet Mask and Default Gateway IP Address
Please refer to Fig.
For example, your network address is 10.1.1.0, and subnet mask is 255.255.255.0. You can change the switch’s default IP address 192.168.1.1 to
10.1.1.1and set the subnet mask to be 255.255.255.0. Then, choose your default gateway, may be it is 10.1.1.254.
| Default Value | Your Network Setting | |
|
|
|
|
| IP Address | 192.168.1.1 | 10.1.1.1 |
| Subnet | 255.255.255.0 | 255.255.255.0 |
| Default Gateway | 192.168.1.254 | 10.1.1.254 |
|
|
|
|
Table
After completing these settings in the switch, it will reboot to have the configuration taken effect. After this step, you can operate the management through the network, no matter it is from a web browser or Network Management System (NMS).
Fig. |
|
15 | Publication date: March., 2011 |
| Revision A1 |