Cisco Systems OL-8376-01 manual 2-10, Fault Description, Explanation, Related Setting

Chapter 2 Fault Descriptions

Radio Interface Faults

Table 2-2	Radio Interface Faults (continued)
Fault Description		Explanation	Related Setting	Recommended Action
Compensation		Errors forced the cancellation of	Not applicable.	Display the Self Healing fault details
calculation did not		Self Healing compensation		page, then select the document with
complete due to errors		calculations.		the eyeglasses. The error messages
				displayed on this page will explain
				the problem.
				Determine the action necessary to
				clear the fault condition.
Compensation finished		Self Healing compensation	Not applicable.	Determine the action necessary to
with errors		calculations finished but there		clear the fault condition.
		were errors. For example, a power		For example, if WLSE determines
		change cannot be applied to a radio
				that five radios are needed to
		because:
				compensate for a down radio and
		1) The community strings for the		only one has bad community strings,
		device are wrong for the AP.		the changes to the other four radios
		2) AP is down or unreachable		will take place.
		3) Wrong configuration set on the
		radio
Compensation did not		Self Healing compensation	Not applicable.	Display the Self Healing fault details
complete due to timeout		calculations took longer than 30		page, then select the document with
of timeout (mins)		minutes.		the eyeglasses. The error messages
				displayed on this page will explain
				the problem.
				Determine the action necessary to
				clear the fault condition.
EAP is disabled		The EAP per SSID has been	Manage Fault	Log in to the access point and enable
		disabled.	Settings >	the Network EAP and Open
		When this fault is cleared, the	Radio-802.11x	authentication.
			Policies >
		following message displays: EAP
			EAP Enforced for
		is enabled
			Cisco Supplicant/
			Non-Cisco
			Supplicant/
			Mixed-Cisco
			Supplicant
Infrastructure SSID		The infrastructure SSID does not	Manage Fault	Log in to the access point and make
policy violation		match the infrastructure SSID set	Settings >	sure the WLSE’s Infrastructure SSID
		on the access point.	Radio-802.11x	matches the access point
		When this fault is cleared, the	Policies >	infrastructure SSID
			Infrastructure SSID
		following message displays:
		Infrastructure SSID is valid.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-10 OL-8376-01