Chapter 1 FAQs and Troubleshooting
Configuration FAQs and Troubleshooting
•Q.Can I give a configuration job a name that is used for a firmware or radio management job?
•Q.Why do I get the following error message when I upload a configuration template with SCP using the Overwrite option: Invalid SSH version running on the device?
•Q.What happens when I apply a configuration to a device with an existing configuration?
•Q.If a template is valid for an access point with an 802.11g radio, can I also apply that template to an access point with an 802.11b radio?
•Q.If a template is valid for a 1310 wireless bridge in bridge mode, can I also apply that template to a 1310 wireless bridge in access point mode?
•Q.If I create a configuration template that includes WEP key settings how can I verify that they were set on the access point.
•Q.How long is the configuration job history kept in the WLSE?
•Q.What mechanism do configuration jobs use to initiate a configuration upload?
•Q.What kinds of job logs are available?
•Q.What is startup configuration template?
•Q.If I make changes to the startup template, will those modifications be automatically uploaded to the access points that already had a startup template applied?
•Q.What is auto configuration?
•Q.Can I use Device Specific settings with Startup templates?
•Q.Why is my configuration job for a crypto key taking so long to complete?
Q.Can I override the SSHv2 option for a regular config job?
A.By default, if you select SSH as the transport protocol for your config job, the WLSE will use either SSHv1 or SSHv2 depending on the device version. For the devices with version 12.3(7) JA or earlier, SSHv1 is used; for version12.3(8)JA or later, SSHv2 is used.
If you want to override the SSHv2 option for devices with version 12.3(8)JA or later, and use SSHv1 instead, you must do the following:
a.Enter the following in your browser window: http://<wlseip>:1741/debug/jobprops.jsp.
b.Select the SSHv1 for the SSH version.
c.Click Save.
Q.Can I use multiple WLSE sessions simultaneously to configure WLSE templates?
A.No. You should not open two sessions of the WLSE at the same time to configure the templates.
Q.Can I give a configuration job a name that is used for a firmware or radio management job?
A.No. Job names cannot be duplicated.
Q.Why do I get the following error message when I upload a configuration template with SCP using the Overwrite option: Invalid SSH version running on the device?
A.This message displays when the access point is running a software version that does not support SCP. SCP is supported starting with version 12.3(4)JA.
Q.What happens when I apply a configuration to a device with an existing configuration?
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
|
| |
|
