Cisco Systems OL-8376-01 manual 2-30, Fault Description, Server Type, Explanation, Related Setting

Chapter 2 Fault Descriptions

AAA Server Faults

Table 2-6	AAA Server Faults (continued)
Fault Description		Server Type	Explanation	Related Setting	Recommended Action
PEAP server is		PEAP	The fault threshold set for	Manage Fault	Verify that the fault threshold is set
Overloaded			the overloaded state has	Settings > AAA >	correctly.
			been exceeded.	PEAP > Response	If the threshold is set correctly,
				Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays: PEAP		fault condition.
			server is OK
RADIUS server is		PEAP	Can be caused by any of the	Manage Fault	Check your server configuration
not available			following reasons:	Settings > AAA >	and make sure that:
			• WLSE IP Address is not	RADIUS >	• The WLSE IP address is
			configured as a NAS on	Response Time	configured as NAS on the
			the server.		server.
			• Shared secret key does		• The shared secret key matches
			not match with the key		the key configured on the
			configured on the		server
			server.
			• Server is unreachable.
			When this fault has been
			cleared, the following
			message displays: RADIUS
			server is available
RADIUS server is		PEAP	The fault threshold set for	Manage Fault	Verify that the fault threshold is set
Degraded			the degraded state has been	Settings > AAA >	correctly.
			exceeded.	RADIUS >	If the threshold is set correctly,
				Response Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays: RADIUS		fault condition.
			server is OK.
RADIUS server is		PEAP	The fault threshold set for	Manage Fault	Verify that the fault threshold is set
Overloaded			the overloaded state has	Settings > AAA >	correctly.
			been exceeded.	RADIUS >	If the threshold is set correctly,
				Response Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays: RADIUS		fault condition.
			server is OK.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-30 OL-8376-01