Cisco Systems OL-8376-01 Switch Faults, 2-31, Fault Description, Explanation, Related Setting

Chapter 2 Fault Descriptions

Switch Faults

Switch Faults

Table 2-7	Switch Faults
Fault Description		Explanation	Related Setting	Recommended Action
CPU utilization is		The fault threshold set for the	Manage Fault Settings >	Verify that the fault threshold is set
Degraded (utilization %)		degraded state has been	Switch > CPU	correctly.
		exceeded.	Utilization	If the threshold is set correctly, review
		When this fault has been		your network to determine the action
		cleared, the following		necessary to clear the fault condition.
		message displays: CPU
		utilization is Ok.
CPU utilization is		The fault threshold set for the	Manage Fault Settings >	Verify that the fault threshold is set
Overloaded		overloaded state has been	Switch > CPU	correctly.
(utilization %)		exceeded.	Utilization	If the threshold is set correctly, review
		When this fault has been		your network to determine the action
		cleared, the following		necessary to clear the fault condition.
		message displays: CPU
		utilization is Ok.
Device was not reachable		The SNMP Agent on the	Manage Fault Settings >	Make sure that the switch SNMP agent
via SNMP		switch is down.	Switch > SNMP	is active.
		When this fault has been	Reachable
		cleared, the following
		message displays: Device
		was reachable via SNMP.
Module is down		The module is down.	Manage Fault Settings >	Check the module in the switch and
		When this fault has been	Switch > Module Status	correct the problem.
		cleared, the following
		message displays: Module is
		up.
Port could not agree with		The port could not agree with	Not applicable.	Make sure the duplex mode on both
other end on duplex mode		the far end on port duplex,		ends match.
		and is in disagree(3) mode.
		When this fault has been
		cleared, the following
		message displays: Port
		duplex state is OK.
Port is administratively		The port has been set to down	Manage Fault Settings >	Confirm that the switch port has been
set to down		by the administrator.	Switch > Port Status	deliberately shut down, and that it is not
		When this fault is cleared, the		down due to some other accidental
				operation.
		following message displays:
		Port is UP.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

OL-8376-01 2-31