Cisco Systems OL-8376-01 manual Leap, Eap

Chapter 2 Fault Descriptions

AAA Server Faults

Table 2-6	AAA Server Faults (continued)
Fault Description		Server Type	Explanation	Related Setting	Recommended Action
EAP-MD5 server is		EAP-MD5	The fault threshold set for	Manage Fault	Verify that the fault threshold is set
Degraded			the degraded state has been	Settings > AAA >	correctly.
			exceeded.	EAP-MD5 >	If the threshold is set correctly,
				Response Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays:		fault condition.
			EAP-MD5 server is OK
EAP-MD5 server is		EAP-MD5	Fault threshold for the	Manage Fault	Verify that the fault threshold is set
Overloaded			overloaded state has been	Settings > AAA >	correctly.
			exceeded.	EAP-MD5 >	If the threshold is set correctly,
				Response Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays:		fault condition.
			EAP-MD5 server is OK
LEAP server is not		LEAP	Can be caused by any of the	Manage Fault	Check the server configuration and
available			following:	Settings > AAA >	make sure that:
			• You enabled this policy	LEAP > Response	• The WLSE IP address is
			and are using a	Time	configured as NAS on the
			non-Cisco client with		server.
			EAP.		• The shared secret key matches
			• WLSE IP Address is not		the key configured on the
			configured as a NAS on		server
			the server.
			• Shared secret key does
			not match the key
			configured on the
			server.
			• Server is unreachable.
			When this fault has been
			cleared, the following
			message displays: LEAP
			server is available
LEAP server is		LEAP	The fault threshold set for	Manage Fault	Verify that the fault threshold is set
Degraded			the degraded state has been	Settings > AAA >	correctly.
			exceeded.	LEAP > Response	If the threshold is set correctly,
				Time
			When this fault has been		review your network to determine
			cleared, the following		the action necessary to clear the
			message displays: LEAP		fault condition.
			server is OK.

FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine

2-28 OL-8376-01