Integra DTR-9.1 appendix Connecting the power, Turning the power on from the remote controller

Connecting the power

SEND/LEARN
indicator
POWER ON	POWER
Standby/On	STNBY
AUDIO MODE
Standby indicator

Master Volume

Standby/On

Standby

AUDIO MUTING

TRACKDISC

RECOPEN/COLSE

DVD

CD

Zone 2 (GRN )

T1

T2

TUN

PH

Rec ( RED )

Video 1

Video 2

Video 3

Video 4

Video 5

Tape 1

Tape 2

Display

DVD

AM

FM

Phono

C D

Open/Close

Power

V1

V2

V3

V–

STEREO

DIRECT

DSP

On Off

1

2

3

SURROUND

THX

DSP

4

5

6

Re-EQ

CH SEL

LEVEL +

7

8

9

DTR-9.1

LATE NIGHT DIMMER

LEVEL –

+ 10

0

ENT

HOME THEATER CONTROLLER

RC-418M

Power

Connecting the power

•The DTR-9.1 is shipped with the main power (POWER) switch in the on position ( ON). When the power cord is plugged in for the first time, the DTR-9.1 will automatically enter the standby state and the STANDBY indicator will light (same condition after step 2 below).

•Before you plug in the DTR-9.1, confirm that all con- nections have been made properly.

•Turning on the power may cause a momentary power surge, which might interfere with other elec- trical equipment on the same circuit, such as com- puters. If this happens, use a wall outlet on a differ- ent circuit.

Turning the power on from the remote controller:

Before you can use the remote controller, you must perform steps 1 and 2 above and place the DTR-9.1 in the standby state.

1.Press the AUDIO MODE button.

2.Press the POWER ON button to turn on the DTR- 9.1 (take it out of the standby state).

•To return the DTR-9.1 to the standby state, press the POWER STNBY button.

1.Plug the power cord into an AC wall outlet.

2.Press the POWER switch to set the DTR-9.1 to standby state.

The STANDBY indicator will light up.

3.Press the STANDBY/ON button to turn on the DTR-9.1. The display will light up and the STANDBY indicator will turn off.

Display

INPUTANALOG

VIDEO

COMPONENT

DVD1

If you press the STANDBY/ON button again, the re- ceiver returns to Standby mode.

27