Integra DTR-9.1 appendix Enjoying music or videos in the remote zone

Enjoying music or videos in the remote zone

POWER

ON

VOL

Standby/On

Standby

Master Volume	AUDIO	MUTING
	TRACK	DISC
	REC	OPEN/COLSE
	DVD	CD

Zone 2 (GRN )

Rec ( RED )

Video 1

Video 2

Video 3

Video 4

Video 5

Tape 1

Tape 2

Open/Close

Display

DVD

AM

FM

Phono

C D

PH

Power

T1

T2

TUN

On Off

V1

V2

V3

V–

STEREO

DIRECT

DSP

1

2

3

SURROUND

THX

DSP

CLEAR

Phones

4

5

6

Re-EQ

CH SEL

LEVEL +

Input selector buttons

7 8 9

LATE NIGHT	DIMMER	LEVEL –
+ 10	0	ENT

DTR-9.1

HOME THEATER CONTROLLER

RC-418M

Zone 2 Off

Controlling the DTR-9.1 from the remote zone

1.Aiming at the remote sensor, press the POWER ON button on the remote controller.

Note:

Be aware that if you start using the system in the remote zone (Zone 2) while a recording is going on in the main zone, the recording is aborted.

2.Press the appropriate input selector button on the remote controller to select the desired source.

3.Adjust the volume on the power amplifier to the desired level.

Controlling the DTR-9.1 without the remote controller

Notes:

•If the Zone 2 button was pressed twice so that the same source is being played in the main and re- mote zones, then changing the input source in the main zone also changes the input source for the re- mote zone.

•In the remote zone, you can only play the source in the 2-channel mode. You cannot play the source in the remote zone in the surround mode.

•If the Rec Out button is pressed in the main room while someone is using the system in the remote zone, the Zone 2 function will be deactivated and the source will turn off in the remote zone.

•The Zone 2 terminal is an analog output. Digital sig- nals are not output. If no sound is heard from the selected input source, check if the component is connected to the analog inputs.

•Please note that some third-party multi-room system components may not be fully compatible with the Integra multi-room system components.

•If you are not using the system in the remote zone, always press the Zone 2 button and then the Off but- ton to turn the Zone 2 function off.

1.Press the Zone 2 button on the DTR-9.1.

2.Select a source.

After pressing the Zone 2 button, you must press an input source button within 8 seconds. To select the same source as that selected for the main zone, press the Zone 2 button twice in succession. The indi- cator above the selected input source will light green. Adjust the volume in the remote zone as de- sired.

Ex.: When the Zone 2 button is pressed twice

Ex.: When the Zone 2 button and then VIDEO 4 button are pressed

49