2.Place the OS/2 Display Driver Diskette in drive A. Type

A:<ENTER> to make this the default drive. Then type INST2X

A:C: <ENTER> (for OS/2 2.1x systems) or INST30 A: C: <ENTER> (for OS/2 Version 3 systems). Once the Install Program is completed, do a system shutdown and reboot.

3.After the system has rebooted, follow these instructions:

A) OS/2 2.1x

Open an OS/2 full-screen or windowed session. At the OS/2 prompt, type DSPINSTL <ENTER> to install the new device driver and configure the video system.

B) OS/2 Version 3

Go to the System Setup folder and run Selective Install to install the new device driver and configure the video system.

Follow the instructions of the program to set up the OS/2 drivers in your system. First, select Primary Display. From the list of Primary Display Adapter Types, select Chips and Technologies 655XX.

From the list of available Display Resolutions, select a display resolution. The correct source directory must be specified. Once the installation is complete, the system must be shut down and restarted for changes to take effect.

WIN-OS/2

Please note the following limitations regarding WIN-OS/2.

1.The WIN-OS/2 full screen session should be set to Enhanced Capability. The default setting is Standard Mode. If this setting is not changed, Windows will not run.

2.WIN-OS/2 should be started by selecting the WIN-OS/2 Full Screen Icon in the Command Prompts folder, or with the WIN command in a DOS Full Screen or OS/2 Full Screen session.

3.Do not start WIN-OS/2 in a DOS or OS/2 Window. The system does not support the enhanced video mode being used in a window, and therefore will not run.

70 PCM-5890 User's Manual

Page 78
Image 78
Intel SBC-455 manual OS/2