Installing DRAM (SIMMs)

The SBC-455 CPU card provides two 72-pin SIMM (Single In-line Memory Module) sockets and supports between 1 MB and 64 MB DRAM.

When installing SIMMs, make sure that Bank 1 is filled first.

Installing SIMMs

Notethatthemodulescanonlyfitintoasocketoneway.

1.Insert the memory module into the socket at a moderate angle.

2.Push the module toward the vertical posts at both ends of the socket until the module is upright and the retaining clips at both ends of the module click into place. When positioned correctly, the pins on top of the vertical posts should corre- spond to the circular holes on the ends of the module.

3.Repeat steps 1 and 2 for each module you install.

Removing SIMMs

If you need to remove a SIMM, follow the procedures below:

1.Supporting the SIMM with a finger, use a pen or a similarly shaped object and press one retaining clip straight down.

2.Repeat for the other side. When released, the retaining clips will push the SIMM up and out of its upright position.

3.Carefully pull the SIMM out of the socket with your fingers.

4.Repeat the above steps for each module you remove.

Chapter 2 Installation 17

Page 25
Image 25
Intel SBC-455 manual Installing Dram SIMMs, Installing SIMMs, Removing SIMMs