Using the Web Console
Column | Description |
|
|
| Specifies which member port is the master port. The master port is always |
| the lowest numbered port. All member ports are configured to use its settings |
Master | and become members of its VLAN. |
| |
| Note: This value will not be displayed on an LACP trunk until it is negotiated |
| with the aggregation partner. |
|
|
| Specifies which member port is the anchor port. The anchor port is |
| responsible for the flooding of multicast frames and for sending control |
Anchor | packets. |
| |
| Note: This value will not be displayed on an LACP trunk until it is negotiated |
| with the aggregation partner. |
|
|
To configure link aggregation load sharing
1.In the left panel, click Link Aggregation Settings.
2.In the top panel, click Load Sharing Algorithm.
3.Select a load sharing algorithm from the following:
Field | Description | |
|
| |
Src Address | Load sharing based on Layer 2 MAC Source Address (SA) | |
|
| |
Dst Address | Load sharing based on Layer 2 MAC Destination Address (DA) | |
|
| |
Src & DST Address | Load sharing based on Layer 2 MAC Source and Destination Address (XOR | |
of SA and DA) | ||
| ||
|
| |
Src IP | Load sharing based on Layer 3 IP Source Address (SIP) | |
|
| |
Dst IP | Load sharing based on Layer 3 IP Destination Address (DIP) | |
|
| |
SRC & DST IP | Load sharing based on Layer 3 IP Source and Destination Address (XOR of | |
SIP and DIP) | ||
| ||
|
|
4. Click Apply
Layer 3 - IP Networking
This section describes how to configure
•IP interfaces
•RIP
•Multicast routing protocols
Setting Up IP Interfaces
Each IP interface on the switch corresponds to a VLAN. A VLAN, which does not have a corresponding IP interface defined for it, will function as a Layer
The switch allows ranges of IP addresses (OSI Layer 3) to be assigned to VLANs (OSI Layer 2). Each VLAN must be configured prior to setting up the corresponding IP interface.
Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual | 125 |
