Intel ZT 8101 10/100 Saving Changes, Admin and User Privileges, Using the Telnet Console

Using the Telnet Console

Note: Remember that APPLY makes changes to the switch configuration for the current session only. All changes (including user additions or updates) must be entered into non-volatile RAM using the Save Changes command on the Main Menu, if you want these changes to be permanent.

Admin and User Privileges

The switch uses two levels of user privileges: Admin and User. Some menu selections available to users with Admin privileges are not be available to those with User privileges.

The table summarizes the Admin and User privileges:

	Admin	User
Switch Configuration Management
Configuration	Yes	Read Only
Network Monitoring	Yes	Read Only
SNMP Community Strings and Trap Stations	Yes	Read Only
Update Firmware and Configuration Files	Yes	No
Ping	Yes	Yes
BOOTP/DHCP Relay and DNS Relay	Yes	Read Only
Factory Reset	Yes	No
Reboot Switch	Yes	No
Advanced Setup	Yes	Read Only
User Account Management
Add/Update/Delete User Accounts	Yes	No
View User Accounts	Yes	No

To log in once you have created a registered user

1.From the Login screen, type in your username and press Enter.

2.Type in your password and press Enter.

The main menu screen will be displayed based on your access level or privilege.

Saving Changes

The ZT 8101 switch has two levels of memory: normal RAM and non-volatile or NV-RAM. Configuration changes are made effective by highlighting APPLY and pressing Enter. When you do this, the settings are immediately applied to the switch software in RAM and immediately take effect.

Some settings, though, require you to restart the switch before they will take effect. Restarting the switch erases all settings in RAM and reloads the stored settings from the NV-RAM. Thus, it is necessary to save all setting changes to NV-RAM before rebooting the switch.

Intel® NetStructure™ ZT 8101 10/100 Ethernet Switch User’s Manual 51